My Columbus 320RS came with the Lippert 3.0 Auto level system. Electric not Hydraulic. Saturday after I dropped the unit from the truck the system went to H$%^! The front landing gear will not go up or down but I do hear the motors turn. When I open the LP tank door I can see the motor shaft and Leg gear shaft turn when I hit the switch to raise or lower. The right rear most jack dropped to the ground without pulling the pin. The Left rear jack and the middle two will not go up or down when in manual or automatic mode. When I press the auto level button on the control I hear motors running, see the display say Grounding front jacks and it just runs and runs and runs (3 minutes) and the jacks will not raise or lower.
I tried resetting the control and erasing the right rear jack error but that did not help. It reset ( I could hear it click) but the jacks still do not go up and down. How could all six jacks fail at the same time but differently?
This unit has been nothing but a pain in the ***** since I bought it! The dealer where I bought it wants $325 up front for travel charge and one hour labor. I bought the extended warranty but they say warranty may not cover it.
Any help appreciated!
:crying:
I tried resetting the control and erasing the right rear jack error but that did not help. It reset ( I could hear it click) but the jacks still do not go up and down. How could all six jacks fail at the same time but differently?
This unit has been nothing but a pain in the ***** since I bought it! The dealer where I bought it wants $325 up front for travel charge and one hour labor. I bought the extended warranty but they say warranty may not cover it.
Any help appreciated!
:crying: